These sterling silver jump rings are saw cut and polished to a high gleam. Spiderchain specializes in precious metal jump rings, and we take pride in the quality of our products. These rings are cleanly cut, consistently sized, and free of partial or mangled rings.
19ga Jump Rings – mm
|Inner Diameter||Rings per Troy Ounce|
Please note that the inner diameter listed is the size of the steel rod that we use to wind that ring size. The finished size will be a tiny bit larger (especially for big/thin rings) because the wire springs back a bit after being wrapped around the rod. And if you want rings with even larger inner diameters than are listed here, please visit the Large Aspect Ratio section of the site.
The rings/ozt numbers in this chart will be closest for sterling silver jump rings. The other metals that we use are slightly less dense than sterling silver. If you’re buying gold filled, brass or copper rings you will get a few more rings in an ounce than you see in the chart.
General Info About Sterling Silver
Pure silver is fairly soft, so it’s usually alloyed with other metals to make it more practical for everyday use. For sterling silver, 92.5% of the weight is silver, with the remaining 7.5% made up by other metal, usually copper. The sterling silver I sell is 92.5% silver and 7.5% copper. You’ll sometimes see sterling silver hallmarked with a “.925” stamp – that refers to the 92.5% silver content. And sometimes it’s simply referred to as 925 silver or 925 sterling. All of these terms are interchangeable, and they all refer to this most common silver alloy – just enough alloying metal added to make it tough enough for everyday use. Wikipedia has a great article on the history of sterling silver.
Working with 19 Gauge Jump Rings
I personally love 19ga jump rings for chainmaille jewelry that’s dainty without being tiny. It’s just a little bit smaller than 18ga and I find that “little bit” makes all the difference to my eye. Of course I make chainmaille in all gauges, but 19 gauge somehow hits a sweet spot for me. I usually use mismatched pliers for 19 gauge: flat-nose in my dominant hand and chain-nose in my off hand. If the weave is especially dense and intricate I’ll sometimes switch to two pairs of chain-nose pliers.